Linux RHEL-10-200532

Verify RHEL 10 is configured so that "firewalld" employs a deny-all, allow-by-exception policy for allowing connections to other systems with the following commands (using ens133 as an example interface): $ sudo firewall-cmd --state running $ sudo firewall-cmd --get-active-zones drop (default) interfaces: ens33 $ sudo firewall-cmd --info-zone=drop | grep target target: DROP $ sudo firewall-cmd --permanent --info-zone=drop | grep target target: DROP If no zones are active on the RHEL 10 interfaces or if runtime and permanent targets are set to an option other than "DROP", this is a finding. Verify the permanent configuration is valid and there are no misconfigured zones or rules with the following command: $ sudo firewall-cmd --check-config success If this command does not return "success", this is a finding.

Configure RHEL 10 so that the "firewalld" daemon employs a deny-all, allow-by-exception policy with the following commands (using ens133 as an example interface): Start by adding the exceptions that are required for mission functionality to the "drop" zone. If SSH access on port 22 is needed, for example, run the following: $ sudo firewall-cmd --permanent --add-service=ssh --zone=drop Reload the firewall rules to update the runtime configuration from the "--permanent" changes made above: $ sudo firewall-cmd --reload Set the default zone to the drop zone: $ sudo firewall-cmd --set-default-zone=drop Note: This is a runtime and permanent change. Add any interfaces to the newly modified "drop" zone: $ sudo firewall-cmd --permanent --zone=drop --change-interface=ens33 Reload the firewall rules for changes to take effect: $ sudo firewall-cmd --reload